Mikrodev products were preferred in the Marmara Highway Energy Monitoring SCADA System located in Türkiye. More than 200 stations located along the highway were integrated into the SCADA system.
- More than 200 stations
- Data transfer to SCADA system via MODBUS protocol
- Energy and power value calculations
- Operation, fault status information tracking
- Energy equipment position location information
- Automatic or manual system control
Other Post
All Posts
Georgian Oil & Gas Corporation (GOGC) Rustavi RMS System
RTU300 series remote terminal unit products and MBS100 series MODBUS gateway product were used in the RMS system commissioned in Georgia. Energy data is monitored over the ViewPLUS SCADA system over M
What is a Distributed Control System (DCS)?
Distributed Control System (DCS) is an automation system and is used to control a manufacturing facility or an industrial process. These systems work in connection with each other by communicating man
HANNOVER MESSE 2023
We have left behind the exciting 5 days of Hannover Messe 2023 Fair, which was held for the 76th time this year and brings together hundreds of thousands of visitors and industry leader companies ever
What are the Differences Between PLC and RTU?
In the world of industrial automation, PLC (Programmable Logic Control) and RTU (Remote Terminal Unit) are two substantial devices. They are both used to automate and monitor process control, however,
OPC UA and MQTT in Industrial Communication: Integration in Brownfield Factories
OPC UA and MQTT: Definition and Fundamental Differences
In the context of industrial communication, OPC UA (Open Platform Communications Unified Architecture) and MQTT (Message Queuing Telemetry Tran
Redundancy Design: Seamless Operation with Dual SCADA Servers, Dual RTUs, and Dual SIM
An outage can start as ordinarily as a single relay falling silent in the field. Then alarms rain down, data flow stops, and decision-making is delayed. In sectors like energy, water, wastewater, oil
Alarm Management ISA-18.2: SCADA Alarms, Event Management, Priority, and Operator Effectiveness
Imagine 3,000 alarms sounding in one shift. The operator tries to pick out the real danger within the noise, stress increases, and errors multiply. A critical pump stops a few minutes later, and the c
IEC 61850, IEC 60870, and DNP3: Strategic Protocol Selection and Architecture in Substation SCADA Projects
As modern energy grids evolve from one-way power flow to two-way, dynamic, and smart grid structures, the backbone of this transformation is formed by communication protocols. In a Substation Automati
RTU or PLC? A Guide to Making the Right Choice in Water and Energy Projects
When you go out to the field, the picture is usually the same: distributed stations, pumping stations, reservoirs, substation yards, and at every point the same question arises: “What should we use to
RTU vs. PLC: Fundamental Comparison in Terms of Differences, Usage Areas, and Control Systems
Success in the field of automation begins with choosing the right control system. RTU (Remote Terminal Unit) and PLC (Programmable Logic Controller) are two fundamental devices used to safely manage c
