In the system, which aims to prevent Turkcell network disconnections in sea buses, the axis control of the base station is carried out according to the sea bus GPS coordinate information.
- 4 MP211 Series PLC’s (One for each sea bus)
- 500 data control via ViewPLUS SCADA
- The first domestically installed rotary antenna control system in Türkiye
- Motion control
- Axis definitions
- Location tracking system
- The antenna is fixed in the desired direction by reading the ferry GPS coordinates and the north angle values of the ferry compass with Mikrodev PLC with NMEA protocol, and calculating the correlation between the base station coordinates that the antenna should focus on
Other Post
All Posts
Salda Lake Environmental Protection Wastewater Management System
MP110 series PLC and ViewPlus SCADA products were used in the wastewater drainage system of the structures around Salda Lake in Burdur Turkey under the leadership of the Republic of Türkiye Ministry o
Israel Cellcom Telecommunication Base Stations Monitoring System
Mikrodev products were used at over 200 stations in the Israel Cellcom Telecommunication Base Stations Monitoring System. In the system, energy monitoring of base stations is carried out, and station
What is SCADA, Who Uses It and How It Works
What is SCADA, Who Uses It and How It Works
What is SCADA?
SCADA refers to a system that collects data from various sensors at a factory, plant, or in other remote locations and then sends this da
Alarm Management ISA-18.2: SCADA Alarms, Event Management, Priority, and Operator Effectiveness
Imagine 3,000 alarms sounding in one shift. The operator tries to pick out the real danger within the noise, stress increases, and errors multiply. A critical pump stops a few minutes later, and the c
HOW TO REDUCE MAİNTENANCE COSTS WİTH AGİNG FUNCTİONS İN PLC PROGRAMMİNG ?
Optimizing Control Systems with PLC, RTU, and SCADA
In the ever-evolving world of industrial automation, Programmable Logic Controllers (PLCs) play a crucial role in controlling and monitoring variou
PTP (IEEE 1588) vs NTP: Millisecond Precision Time Synchronization in Industrial Networks and SCADA
How accurate is time alignment in industrial systems? Time synchronization means reliable data and accurate decisions in the field. An incorrect clock creates large gaps in fault analysis and quality
What are the Differences Between PLC and RTU?
In the world of industrial automation, PLC (Programmable Logic Control) and RTU (Remote Terminal Unit) are two substantial devices. They are both used to automate and monitor process control, however,
OPC UA and MQTT in Industrial Communication: Integration in Brownfield Factories
OPC UA and MQTT: Definition and Fundamental Differences
In the context of industrial communication, OPC UA (Open Platform Communications Unified Architecture) and MQTT (Message Queuing Telemetry Tran
Understanding the Differences Between PLC, DCS & SCADA
Understanding the Differences Between PLC, DCS & SCADA - A Selection Guide
In today's industrial landscape, the selection of an appropriate control system architecture plays a pivotal role in ens
Digital Transformation in Transformer Substations: SCADA and Substation Automation
Energy is the lifeblood of modern civilization. In the process of delivering this energy from generation to the end consumer in an uninterrupted, high-quality, and secure manner, the most critical nod
