RTU and PLC products installed in more than 200 wells, warehouses and pumping centers throughout Trabzon are managed through the ViewPlus SCADA software in the TİSKİ Control Center.
- Over 200 wells, warehouses and pump stations
- Over 200 MP211 series PLC and RTU300 series RTU
- 10000 data control via ViewPLUS SCADA
- Hot stand by redundant SCADA
- Data transmission to Viewplus SCADA via MODBUS and IEC 60870-5-104
- Detection of water leaks, preventive or corrective actions
- Electricity savings by using motors/pumps efficiently
- Water quality control by monitoring parameters such as chlorine, PH meter, turbidity
- Alarm tracking
- Daily, monthly, annual reporting
Other Post
All Posts
OPC UA and MQTT in Industrial Communication: Integration in Brownfield Factories
OPC UA and MQTT: Definition and Fundamental Differences
In the context of industrial communication, OPC UA (Open Platform Communications Unified Architecture) and MQTT (Message Queuing Telemetry Tran
Kayseray Energy Monitoring and Control SCADA System
Energy monitoring and control, catenary line monitoring and control and switch position information of more than 20 substations within Kayseray, a light rail public transportation system that started
PTP (IEEE 1588) vs NTP: Millisecond Precision Time Synchronization in Industrial Networks and SCADA
How accurate is time alignment in industrial systems? Time synchronization means reliable data and accurate decisions in the field. An incorrect clock creates large gaps in fault analysis and quality
Kocaeli-Gebze VI. (IMES) OIZ Energy Tracking System
Mikrodev IoT protocol converter product family was preferred in the IMES Organized Industrial Zone Automatic Meter Reading System Project. In the current system, data of more than 600 electricity mete
Comparison of MODBUS and IEC 60870-5-104 Communication Protocols
MODBUS and IEC 60870-5-104 are two different communication protocols widely used in industrial automation and control systems. They have different features and are used for different purposes. There a
IEC 61850, IEC 60870, and DNP3: Strategic Protocol Selection and Architecture in Substation SCADA Projects
As modern energy grids evolve from one-way power flow to two-way, dynamic, and smart grid structures, the backbone of this transformation is formed by communication protocols. In a Substation Automati
Redundancy Design: Seamless Operation with Dual SCADA Servers, Dual RTUs, and Dual SIM
An outage can start as ordinarily as a single relay falling silent in the field. Then alarms rain down, data flow stops, and decision-making is delayed. In sectors like energy, water, wastewater, oil
What is SCADA, Who Uses It and How It Works
What is SCADA, Who Uses It and How It Works
What is SCADA?
SCADA refers to a system that collects data from various sensors at a factory, plant, or in other remote locations and then sends this da
WHAT IS THE IEC61850 ?
What is the IEC61850 ?
IEC61850, especially used in electrical distribution systems, is a communication protocol. IEC61850 was developed to standardize and facilitate data exchange between components
RTU or PLC? A Guide to Making the Right Choice in Water and Energy Projects
When you go out to the field, the picture is usually the same: distributed stations, pumping stations, reservoirs, substation yards, and at every point the same question arises: “What should we use to
