RTU300 series remote terminal unit products and MBS100 series MODBUS gateway product were used in the RMS system commissioned in Georgia. Energy data is monitored over the ViewPLUS SCADA system over MODBUS and IEC 60870-5-104 protocol. In the current installed system:
- Reducing and metering system control in Rustavi, Georgia
- Mikrodev RTU300 and MBS100 gatewey
- 2000 tag ViewPLUS SCADA licence
- Over 1000 data control
- Instant data transfer to ViewPLUS SCADA over IEC 60870-5-104 protocol
- Gas transmission line environment data(pressure, valve position, etc.)
- Monitoring measuring data
- Fault information tracking on the basis of the system
- Daily, monthly, annual reporting on a station basis
Other Post
All Posts
What is SCADA, Who Uses It and How It Works
What is SCADA, Who Uses It and How It Works
What is SCADA?
SCADA refers to a system that collects data from various sensors at a factory, plant, or in other remote locations and then sends this da
Northern Marmara Highway (Türkiye) Energy Monitoring System
Mikrodev products were preferred in the Marmara Highway Energy Monitoring SCADA System located in Türkiye. More than 200 stations located along the highway were integrated into the SCADA system.
What is RTU and How Does It Work?
RTU stands for "Remote Terminal Unit" in English. Used in industrial automation systems, RTU is a type of hardware component used to increase the functionality of a device. These modules are used to e
Georgian Oil & Gas Corporation (GOGC) Rustavi RMS System
RTU300 series remote terminal unit products and MBS100 series MODBUS gateway product were used in the RMS system commissioned in Georgia. Energy data is monitored over the ViewPLUS SCADA system over M
Increasing Efficiency: Using MODBUS Gateway in PLC Programming
In the rapidly evolving landscape of industrial automation, the integration of Programmable Logic Controllers (PLCs) and communication protocols holds vital importance. The aim of this article is to p
What Is RTU Device?
What Is RTU Device?
RTUs (Remote Terminal Units) are important components used in industrial automation systems. These devices communicate with field devices (sensors, actuators, switches, etc.) and
PTP (IEEE 1588) vs NTP: Millisecond Precision Time Synchronization in Industrial Networks and SCADA
How accurate is time alignment in industrial systems? Time synchronization means reliable data and accurate decisions in the field. An incorrect clock creates large gaps in fault analysis and quality
Kocaeli-Gebze VI. (IMES) OIZ Energy Tracking System
Mikrodev IoT protocol converter product family was preferred in the IMES Organized Industrial Zone Automatic Meter Reading System Project. In the current system, data of more than 600 electricity mete
Alarm Management ISA-18.2: SCADA Alarms, Event Management, Priority, and Operator Effectiveness
Imagine 3,000 alarms sounding in one shift. The operator tries to pick out the real danger within the noise, stress increases, and errors multiply. A critical pump stops a few minutes later, and the c
What is Programmable Logic Controller Systems (PLC)?
What is Programmable Logic Controller Systems (PLC)?
A PLC is an electronic device used to perform sequencing, timing, speed and motion controls in industrial systems. These devices allow for logica
